Rp110.000,00

DST ARM Stamp LPC1114 ARM Low Cost System
[070-0188]

DST ARM Stamp LPC1114 ARM Low Cost System
LPC1114 Specification:
 System
o ARM Cortex-M0 processor, running at frequencies up to 50Mhz
o ARM Cortex-M0 built in Nested Vector Interrupt Controller(NVIC)
o Serial Wire Debug
o System tick timer
 Memory
o 32KB on-chip flash programming memory
o 8KB SRAM
o In-System Programming(ISP), In-Application Programming(IAP) via on-chip bootloader
 Digital Peripheral
o 42 General Purpose I/O pin configurable pull-up/pull-down resistors
o GPIO pin can be used as edge and level sensitive interrupt source
o High current output driver (20mA) on one pin
o High current sink driver (20mA) on two I2C bus pin in Fast Mode Plus
o 4 general purpose timer/counter with a total of four capture input and 13 match output
o Programmable watchdog timer
 Analog peripheral
o 10 bit ADC with input multiplexing among 8 pins
 Serial peripheral
o UART with fractional baudrate generation, internal FIFO, rs485 support
o 2 SPI controllers with SSP features and with FIFO and multiprotocol capabilities
o I2C bus interface supporting full I2C bus specification and fast mode plus with a data rate 1Mbit/s with multiple address recognition and monitor mode
 Clock Generation
o 12Mhz internal RC oscillator trimmed to 1% accuracy that can optionally be used as system clock
o Crystal oscillator with freq range 1-25Mhz
o Programmable watch oscillator with a frequency range 7.8 Khz-1.8Mhz
o PLL allow CPU operation up to maximum CPU rate without the need for a high frequencies crystal. May be run from the system oscillator or the internal RC oscillator
o Clock output function with divider that can reflect the system oscillator clock, IRC oscillator, cpu clock and watchdog oscillator.
 Power control
o Integrated PMU (power management unit) to minimize power consumption during sleep, deep sleep, and deep power down mode
o Three reduce power mode: sleep, deep sleep, and deep power down mode
o Processor wake up from deep sleep mode via a dedicated start logic using up to 13 functional pin.
o POR(power on reset)
o Brownout detect with four separate threshold for interrupt and force reset
 Unique serial number for device indentification
 Single 3.3V power supply (1.8-3.6V)
DST ARM Stamp Specification
 UART TTL Level
 Onboard Power Regulator: 9-30 Volt DC
 1 bit LED Logic Tester
 Extra VCC 3.3V & GND Connection
 JTAG Header
 42 bit I/O
 40p DIP connection compatible with DST-51, DST-AVR, Trainer Board TRN-02, Delta Robo Kits
 PCB Through hole 2.8 x 6.2 cm

Aplikasi:
- Mengenal ARM Cortex M0
- Bekerja dengan LPC1xxx
- Bekerja dengan LPC1xxx II
- AN0173 Antarmuka LCD M1632 dengan LPC1114 pada Modul DST-ARM
Untuk informasi lebih lanjut, lihat penjelasan produk ini di data sheet.
Review
Pembuat
Cari Cepat
 
Gunakan kata kunci untuk mencari produk yang anda inginkan.
Pencarian Lanjutan
Mata Uang
Bahasa
English Indonesia